Solar-Log 200 Manual page 182

Configuration Menu
Resetting inverter configuration section
If the Device Detection needs to be started again, it is recommended to delete the previous inverter confi-
guration with this function.
Procedure
•
Click on
•
If you are sure that the inverter configuration should be deleted, click on Continue. Otherwise
on Cancel.
•
The data and inverter configuration are deleted.
•
The Solar-Log™ reboots itself.
Restore factory settings section
This function restores the Solar-Log™ to its factory settings. All of the yield data and configuration is dele-
ted.
Procedure
•
Click on
•
If you are sure that the data should be deleted, click on Continue. Otherwise click on
•
The factory settings are being restored
•
The Solar-Log™ reboots itself.
Note!
Note!
182
RESET.
RESET.
The network settings remain when this function is used.
The reset button on the device has to be used to delete all of the settings, including
network settings, for Solar-Log™ devices without a display (Solar-Log 200, 250 and
300). The Solar-Log™ is then set to automatically receive its IP address from the router.
(DHCP)
=> only with router or switch.
click
Cancel.