Fig.: Display: Initial Configuration Language Selection; Fig.: Display: Ip Address Settings In The Initial Configuration - Solar-Log 200 Manual

Initial configuration (only Solar-Log 1200)
The initial configuration is automatically started for the initial setup. However, it can also be started at any
Start | Initial Configuration
time from the
Procedure:
•
After the Solar-Log 1200, 1200 starts, select the system language

Fig.: Display: Initial configuration language selection

•
Enter the IP address for the Solar-Log™ in the second step.
Alternately, check obtained IP address automatically if the Solar-Log™ is connected to a router
with the DHCP service enabled.

Fig.: Display: IP address settings in the initial configuration

Direct Device Configurations (Solar-Log 1200 and 2000)
menu.
259