Table of Contents
Advertisement
Figure 2-13 AP-600 Mounted on a Wall
15. Replace the front cover.
16. Replace the cable cover.
17. Turn on the AP-600.
Ceiling Mount
Follow these steps to mount the AP-600 to a ceiling:
1. Unplug the Access Point's power supply, if necessary.
2. Use a Phillips screwdriver to attach the metal base to the underside of the AP-600, if necessary. See
Metal Base
for an illustration.
3. Feed a mounting screw through each of the four rubber feet. The AP-600 comes with four 3.5 mm x 40 mm
pan-head screws.
4. Remove the screws from the rubber feet.
5. Turn the AP-600 upside down position the base against the ceiling where you want to mount the unit.
6. Mark the center of the four mounting holes in the rubber feet.
7. Set the AP-600 aside and drill a hole at each of the locations you marked above. Each hole should be wide enough
to hold a mounting plug (which is 6 mm x 35 mm).
8. Insert a plug into each hole. The AP-600 comes with four 6 mm x 35 mm plugs.
9. Insert the screws into the holes you made previously in the rubber feet.
10. Insert the screws into the wall plugs. Use a screwdriver to tighten the screws and attach the Access Point's metal
base to the ceiling.
Installation & Basic Configuration
Attach the
30
Advertisement
Table of Contents
