Table of Contents
Advertisement
Set WEP Encryption for the Wireless Interface
!
& $ 8 7 , 2 1
& $ 8 7 , 2 1
& $ 8 7 , 2 1
& $ 8 7 , 2 1
Wireless clients must be configured with the same encryption key to be able to communicate with the AP-600.
The AP-600 can only support one Key Length (so each of the configured keys must have the same length).
The available key sizes vary based on the Access Point's model. See
for more information.
You can set up to four encryption keys. This example describes setting encryption Key 1 on the wireless card in Slot A.
[Device Name]>set wifsec 3 encryptstatus enable encryptkey1 <WEP key (number of characters
vary depending on AP model)> encryptkeytx 1
[Device Name]>show wifsec
Figure A-14 Result of "show wifsec" CLI Command
Download an AP-600 Configuration File from your TFTP Server
Begin by starting your TFTP program. It must be running and configured to transmit and receive.
[Device Name]>set tftpfilename <file name> tftpfiletype config
[Device Name]>show tftp (to ensure the filename, file type, and the IP address are correct)
[Device Name]>download *
[Device Name]>reboot 0
After following the complete process (above) once, you can download a file of the same name (so long as all the other
parameters are the same), with the following command:
[Device Name]>download *
Backup your AP-600 Configuration File
Begin by starting your TFTP program. It must be running and configured to transmit and receive.
[Device Name]>upload <TFTP Server IP address> <tftpfilename (such as "config.sys")> config
[Device Name]>show tftp (to ensure the filename, file type, and the IP address are correct)
After setting the TFTP parameters, you can backup your current file (so long as all the other parameters are the same),
with the following command:
[Device Name]>upload *
tftpipaddr <IP address of your TFTP server>
Command Line Interface (CLI)
Security Encryption Key Length Table
105
Advertisement
Table of Contents
