Proxim ORINOCO AP-600B User Manual page 23

Figure 2-8 Scan List
7. Locate the MAC address of the AP-600 you want to initialize within the Scan List.
1 2 7 ( 1 2 7 ( 1 2 7 ( 1 2 7 (
If your Access Point does not show up in the Scan List, click the Rescan button to update the display. If the
unit still does not appear in the list, see
Access Point, it may take up to five minutes for the unit to appear in the Scan List.
8. Do one of the following:
• If the AP-600 has been assigned an IP address by a DHCP server on the network, write down the IP address
and click Cancel to close ScanTool. Proceed to
interface using this IP address.
• If the AP-600 has not been assigned an IP address (in other words, the unit is using its default IP address,
169.254.128.132), follow these steps to assign it a static IP address that is valid on your network:
1. Highlight the entry for the AP-600 you want to configure.
2. Click the Change button.
— Result: the Change screen appears.
Figure 2-9 Scan Tool Change Screen
Installation & Basic Configuration
Troubleshooting for suggestions. Note that after rebooting an
Setup Wizard for information on how to access the HTTP
23