LED Indicators
The AP-600 has four LED indicators. The LEDs are identified in
behavior:
Power
Ethernet Link
Solid Green
Green when link
exists
Solid Amber
Solid Amber
Solid Green
Solid Amber
Solid Red
Off
Blinking Red
Blinking Red or Off
Blinking Red
Off
Solid Red
Blinking Red or Off
Solid Red
Off
Blinking Amber
Blinking Amber or Off
Solid Amber
Solid Amber
n/a
n/a
n/a
n/a
Figure 2-16 LED Indicators Illustrated
Related Topics
The Setup Wizard helps you configure the basic AP-600 settings required to get the unit up and running. The AP-600
supports many other configuration and management options. The remainder of this user guide describes these options
in detail.
–
See
Advanced Configuration
HTTP interface.
–
See
Monitor Information
–
See
Commands
for information on the commands supported by the Access Point's HTTP interface.
–
See
Troubleshooting
for troubleshooting suggestions.
–
See
Command Line Interface (CLI)
Ethernet Activity
Green flash
with data activity
Solid Amber
Solid Amber
Off
Blinking Red
Off
Solid Red
Off
Blinking Amber or Off Off
Solid Amber
n/a
Amber
for information on configuration options that are available within the Access Point's
for information on the statistics displayed within the Access Point's HTTP interface.
for information on the CLI interface and for a list of CLI commands.
Installation & Basic Configuration
LED Indicators Illustrated
Wireless Activity
Indication
Green flash
Normal Operation
with data activity
Solid Amber
Rebooting
Solid Amber
Reset to Factory Defaults command issued
Off
SDRAM Test Failure
Off
Hardware Timer Test Failure
Blinking Red
Flash Test Failure
Off
Ethernet Test Failure
Solid Red
Wireless Test Failure
Missing or bad AP image
Solid Amber
Missing or bad bootloader image (all LEDs
remain solid amber)
Red
Wireless radio is not working properly
Amber
Indicated interface in administrative down state
Power LED
Ethernet Link LED
Ethernet Activity LED
Wireless Activity LED
and exhibit the following
32