Table of Contents
Advertisement
Figure 2-10 Enter Network Password
Figure 2-11
Setup Wizard
5. Click Setup Wizard to begin. If you want to configure the AP-600 without using the Setup Wizard, click Exit and
see
Advanced
Configuration.
The Setup Wizard supports the following navigation options:
•
Save & Next Button: Each Setup Wizard screen has a Save & Next button. Click this button to submit any
changes you made to the unit's parameters and continue to the next page. The instructions below describe
how to navigate the Setup Wizard using the Save & Next buttons.
•
Navigation Panel: The Setup Wizard provides a navigation panel on the left-hand side of the screen. Click
the link that corresponds to the parameters you want to configure to be taken to that particular configuration
screen. Note that clicking a link in the navigation panel will not submit any changes you made to the unit's
configuration on the current page.
•
Exit: The navigation panel also includes an Exit option. Click this link to close the Setup Wizard at any time.
!
& $ 8 7 , 2 1
& $ 8 7 , 2 1
& $ 8 7 , 2 1
& $ 8 7 , 2 1
If you exit from the Setup Wizard, any changes you submitted (by clicking the Save & Next button) up to that
point will be saved to the unit but will not take effect until it is rebooted.
6. Configure the System Configuration settings and click Save & Next. See
7. Configure the Access Point's Basic IP address settings, if necessary, and click Save & Next. See
Parameters
for more information.
Installation & Basic Configuration
System
for more information.
Basic IP
25
Advertisement
Table of Contents
