Table of Contents
Advertisement
•
Gateway IP Address: The AP-600 will assign the specified address to its DHCP clients.
•
Primary DNS IP Address: The AP-600 will assign the specified address to its DHCP clients.
•
Secondary DNS IP Address: The AP-600 will assign the specified address to its DHCP clients.
•
Number of IP Pool Table Entries: This is a read-only field that reports the number of IP address pools currently
configured.
•
IP Pool Table Entry: This entry specifies a range of IP addresses that the AP can assign to its wireless clients.
Click Add to create a new entry. Click Edit to change an existing entry. Each entry contains the following field:
–
Start IP Address
–
End IP Address
–
Default Lease Time (optional): The default time value for clients to retain the assigned IP address. DHCP
automatically renews IP Addresses without client notification. This parameter supports a range between 0 and
86400 seconds. The default is 86400 seconds.
–
Maximum Lease Time (optional): The maximum time value for clients to retain the assigned IP address.
DHCP automatically renews IP Addresses without client notification. This parameter supports a range
between 0 and 86400 seconds. The default is 86400 seconds.
–
Comment (optional)
–
Status: IP Pools are enabled upon entry in the table. You can also disable or delete entries by changing this
field's value.
1 2 7 (
1 2 7 (
1 2 7 (
1 2 7 (
You must reboot the Access Point before changes to any of these DHCP server parameters take effect.
Link Integrity
The Link Integrity feature checks the link between the AP-600 and the nodes on the Ethernet backbone. These nodes
are listed by IP address in the Link Integrity IP Address Table. The AP-600 periodically pings the nodes listed within the
table. If the AP-600 loses network connectivity (that is, the ping attempts fail), the AP-600 disables its wireless
interface until the connection is restored. This forces the unit's wireless clients to switch to another Access Point that
still has a network connection. Note that this feature does not affect WDS links (if applicable).
Figure 4-4
Link Integrity Configuration Screen
Advanced Configuration
39
Advertisement
Table of Contents
