Installing The Security Cover; Mounting The Ap-4000; Mounting The Ap-4000 To A Ceiling - Proxim AP-4000 User Manual

Getting Started
Hardware Installation

Installing the Security Cover

You can optionally install a security cover to deter unauthorized access to the AP-4000. The security cover is a plastic cover that prevents
access to the cabling and to the Reset and Reload buttons.
NOTE
You cannot connect an RS-232 cable to the AP-4000 when a security cover is installed.
1. Slide the hinging end of the security cover into the hole on the rear panel of the AP-4000 to the left of the connectors.
2. Use two screws to screw the right side of the security cover to the RS-232 screw holes on the rear panel of the AP-4000.

Mounting the AP-4000

Conduct a site survey to determine the best location for your device. Once you have chosen a final location for your unit, mount the AP-4000
to a wall or a T-bar ceiling as follows:

Mounting the AP-4000 to a Ceiling

1. Attach the mounting plate to the bottom of the AP-4000 by lining up the keyholes and attaching it with two screws.
2. Snap the tabs onto the ceiling T-bar. Rotate the AP-4000 until it snaps on to the T-bar.
Figure 2-4 AP-4000 Mounting Plate
AP-4000 User Guide
22