Other Network Settings; Configure The Ap-600 As A Dhcp Server; Configure The Dns Client - Proxim ORINOCO AP-600B User Manual

Other Network Settings

There are other configuration settings that you may want to set for the AP-600. Some of them are listed below.
–

Configure the AP-600 as a DHCP Server

–

Configure the DNS Client

– Maintain Client Connections using Link Integrity
– Change your Wireless Interface Settings
– Set Ethernet Speed and Transmission Mode
– Set Interface Management Services
– Configure MAC Access Control
– Set RADIUS Parameters
1 2 7 ( 1 2 7 ( 1 2 7 ( 1 2 7 (
Refer to Advanced Configuration
Configure the AP-600 as a DHCP Server
1 2 7 ( 1 2 7 ( 1 2 7 ( 1 2 7 (
You must have at least one entry in the DHCP Server IP Address Pool Table before you can set the DHCP
Server Status to Enable.
[Device Name]>set dhcpstatus disable
[Device Name]>set dhcpippooltbl 0 startipaddr <start ip address>
endipaddr <end ip address>
[Device Name]>set dhcpgw <gateway ip address>
[Device Name]>set dhcppridnsipaddr <primary dns ip address>
[Device Name]>set dhcpsecdnsipaddr <secondary dns ip address>
[Device Name]>set dhcpstatus enable
[Device Name]>reboot 0
!
& $ 8 7 , 2 1 & $ 8 7 , 2 1
& $ 8 7 , 2 1 & $ 8 7 , 2 1
Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on the
network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling this
feature with incorrect address pools will cause problems on your network.
Configure the DNS Client
[Device Name]>set dnsstatus enable
[Device Name]>set dnsprisvripaddr <IP address of primary DNS server>
[Device Name]>set dnssecsvripaddr <IP address of secondary DNS server>
[Device Name]>set dnsdomainname <default domain name>
[Device Name]>show dns
Figure A-15 Results of "show dns" CLI command
for more information on these settings.
Command Line Interface (CLI)
106