Table of Contents
Advertisement
7. Enter only the following statements:
[Device name]> set ipaddrtype static
[Device name]> set ipaddr <Access Point IP Address>
[Device name]> set ipsubmask <IP Mask>
[Device name]> set tftpipaddr <TFTP Server IP Address>
[Device name]> set tftpfilename <AP Image File Name, including file extension>
[Device name]> set ipgw <Gateway IP Address>
[Device name]> show ip (to confirm your new settings)
[Device name]> show tftp (to confirm your new settings)
[Device name]> reboot 0
Example:
[Device name]> set ipaddrtype static
[Device name]> set ipaddr 10.0.0.12
[Device name]> set ipsubmask 255.255.255.0
[Device name]> set tftpipaddr 10.0.0.20
[Device name]> set tftpfilename MyImage.bin
[Device name]> set ipgw 10.0.0.30
[Device name]> show ip
[Device name]> show tftp
[Device name]> reboot 0
Result: The AP-600 will reboot and then download the image file. You should see downloading activity begin after
a few seconds within the TFTP server's status screen.
8. When the download process is complete, configure the AP-600 as described in
and
Advanced
Configuration.
Setting IP Address using Serial Port and Normal CLI
Use the following procedure to set an IP address over the serial port using the CLI. The network administrator typically
provides the AP-600 IP address.
Hardware and Software Requirements
•
Standard straight-through serial data (RS-232) cable with a one male DB-9 connector and one female DB-9
connector. The AP-600 comes with a female 9-pin serial port.
•
ASCII Terminal software, such as HyperTerminal.
Attaching the Serial Port Cable
1. Unlock and remove the cable cover from the AP-600.
2. Remove the front cover from the AP-600 to reveal the serial port.
3. Connect one end of the serial cable to the AP-600 and the other end to a serial port on your computer.
4. Power on the computer and AP-600, if necessary.
Initializing the IP Address using CLI
After installing the serial port cable, you may use the CLI to communicate with the AP-600. CLI supports most generic
terminal emulation programs, such as HyperTerminal (which is included with the Windows operating systems). In
addition, many web sites offer shareware or commercial terminal programs you can download. Once the IP address
has been assigned, you can use the HTTP interface or the CLI over Telnet to complete configuration.
Follow these steps to assign the AP-600 an IP address:
1. Open your terminal emulation program (like HyperTerminal) and set the following connection properties:
•
Com Port: <COM1, COM2, etc., depending on your computer>
•
Baud rate: 9600
•
Data Bits: 8
•
Stop bits: 1
•
Flow Control: None
•
Parity: None
Troubleshooting
Installation & Basic Configuration
88
Advertisement
Table of Contents
