Maintain Client Connections Using Link Integrity; Change Your Wireless Interface Settings - Proxim ORINOCO AP-600B User Manual

Maintain Client Connections using Link Integrity

[Device Name]>show linkinttbl (this shows the current links)
[Device Name]>set linkinttbl <1-5 (depending on what table row you wish to address)>
ipaddr <ip address of the host computer you want to check>
[Device Name]>set linkintpollint <the interval between link integrity checks>
[Device Name]>set linkintpollretx <number of times to retransmit before considering
the link down>
[Device Name]>set linkintstatus enable
[Device Name]>show linkinttbl (confirm new settings)
[Device Name]>reboot 0

Change your Wireless Interface Settings

See Wireless (AP-600a) or
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device Name]>set wif 3 autochannel <enable/disable>
[Device Name]>reboot 0
Enable 2X Turbo Mode (AP-600a Only)
[Device Name]>set wif 3 turbo <enable/disable>
[Device Name]>reboot 0
Enable/Disable Interference Robustness (AP-600b Only)
[Device Name]>set wif 3 interrobust <enable/disable>
Enable/Disable Closed System (AP-600b Only)
[Device Name]>set wif 3 closedsys <enable/disable>
1 2 7 ( 1 2 7 ( 1 2 7 ( 1 2 7 (
When disabled, a client configured with the Network Name "ANY" can connect to the AP-600b. This feature is
not currently available for the AP-600a.
Enable/Disable Load Balancing (AP-600b Only)
[Device Name]>set wif 3 ldbalance <enable/disable>
Enable/Disable Medium Density Distribution (AP-600b Only)
[Device Name]>set wif 3 meddendistrib <enable/disable>
Wireless (AP-600b) for information on the parameters listed below.
Command Line Interface (CLI)
107