Parameter Tables - Proxim ORINOCO AP-600B User Manual

Parameter Tables

Objects contain groups that contain both parameters and parameter tables.
Use the following Tables to configure the Access Point. Columns used on the tables include:
— Name - Parameter, Group, or Table Name
— Type - Data type
— Values - Value range, and default value, if any
— Access = access type, R = Read Only (show), RW = Read-Write (can be "set"), W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
• System Parameters - Access Point system information
– Inventory Management Information
• Network Parameters - IP and Network Settings
– IP Configuration Parameters
— DNS Client for RADIUS Name Resolution
– DHCP Server Parameters
– Link Integrity Parameters
• Interface Parameters
– Wireless Interface Parameters
— Wireless Distribution System (WDS) Parameters (AP-600b Only)
– Ethernet Interface Parameters
• Management Parameters
– SNMP Parameters
– HTTP (web browser) Parameters
– Telnet Parameters
– Serial Port Parameters
– TFTP Server Parameters
– IP Access Table Parameters
• Filtering Parameters
– Ethernet Protocol Filtering Parameters
– Static MAC Address Filter Table
– Proxy ARP Parameters
– IP ARP Filtering Parameters
– Broadcast Filtering Table
– TCP/UDP Port Filtering
• Alarms Parameters
– SNMP Table Host Table Parameters
– Syslog Parameters
• Bridge Parameters
– Spanning Tree Parameters
– Storm Threshold Parameters
– Intra BSS Subscriber Blocking
– Packet Forwarding Parameters
• Security Parameters - Access Point security settings
– Wireless Interface Security Parameters
– MAC Access Control Parameter
• RADIUS Parameters
– Primary and Backup RADIUS Server Table Parameters
• Other Parameters
– IAPP Parameters
– SpectraLink VoIP Parameters (AP-600b Only)
- Hardware, firmware, and software version information
- Configure the Access Point's IP settings
- Enable or disable dynamic host configuration
- Monitor link status
- Configure Wireless and Ethernet settings
- Set the speed and duplex of the Ethernet port
- Control access to the AP-600's management interfaces
- Set read and read/write passwords
- Set up the graphical web browser interface
- Telnet Port setup
- Serial Port setup
- Set up for file transfers; specify IP Address, file name, and file type
- Configure range of IP addresses that can access the AP-600
- Control network traffic based on protocol type
- Enable and disable specific addresses
- Enable or disable proxy ARP for wireless clients
- Control which ARP messages are sent to wireless clients based on IP settings
- Control the type of broadcast packets forwarded to the wireless network
- Filter IP packets based on TCP/UDP port
- Enter the list of IP addresses that will receive alarms from the AP-600
- Configure the AP-600 to send Syslog information to network servers
- Used to help prevent network loops
- Set threshold for number of broadcast packets
- Enable or disable peer to peer traffic on the same AP
- Redirect traffic from wireless clients to a specified MAC address
- Configure WEP encryption settings
- Control wireless access based on MAC address
- Enable or disable the Inter-Access Point Protocol
Command Line Interface (CLI)
- Configure the Access Point as a DNS client
- Configure the WDS partnerships
- RADIUS Authentication and Accounting information
- Enable or disable SpectraLink Voice over IP feature
112