Table of Contents
Advertisement
Event
Priority
LOG_EMERG
LOG_ALERT
LOG_CRIT
LOG_ERR
LOG_WARNING
LOG_NOTICE
LOG_INFO
LOG_DEBUG
Configuring Syslog Event Notifications
You can configure the following Syslog settings from the HTTP interface:
•
Enable Syslog: Place a check mark in the box provided to enable system logging.
•
Syslog Port Number: This field is read-only and displays the port number (514) assigned for system logging.
•
Syslog Lowest Priority Logged: The AP-600 will send event messages to the Syslog server that correspond to
the selected priority and above. For example, if set to 6, the AP-600 will transmit event messages labeled priority 0
to 6 to the Syslog server(s).
•
Syslog Host Table: This table specifies the IP addresses of a network servers that the AP-600 will send Syslog
messages to. Click Add to create a new entry. Click Edit to change an existing entry. Each entry contains the
following field:
–
IP Address: Enter the IP Address for the management host.
–
Comment: Enter an optional comment such as the host name.
–
Status: The entry is enabled automatically when saved (so the Status field is only visible when editing an
entry). You can also disable or delete entries by changing this field's value.
Figure 4-14 Syslog Configuration Screen
Description
0
system is unusable
1
action must be taken immediately
2
critical conditions
3
error conditions
4
warning conditions
5
normal but significant condition
6
informational
7
debug-level messages
Advanced Configuration
56
Advertisement
Table of Contents
