Bootloader Cli - Proxim ORINOCO AP-600B User Manual

Bootloader CLI

The Bootloader CLI is a minimal subset of the normal CLI used to perform initial configuration of the AP-600. This
interface is only accessible via the serial interface if the AP-600 does not contain a software image or a download
image command over TFTP has failed.
The Bootloader CLI provides you with the ability to configure the initial setup parameters as well as download a
software image to the device.
The following functions are supported by the Bootloader CLI:
– configuration of initial device parameters using the set command
– show command to view the device's configuration parameters
– help command to provide additional information on all commands supported by the Bootloader CLI
– reboot command to reboot the device
The parameters supported by the Bootloader CLI (for viewing and modifying) are:
– System Name
– IP Address Assignment Type
– IP Address
– IP Mask
– Gateway IP Address
– TFTP Server IP Address
– Image File Name (including the file extension)
The following lists display the results of using the help command in the Bootloader CLI:
Figure A-1 Results of "help" bootloader CLI command
The following lists display the results of using the show command in the Bootloader CLI:
Figure A-2 Results of "show" bootloader CLI command
Command Line Interface (CLI)
94