Set Ethernet Speed And Transmission Mode; Set Interface Management Services - Proxim ORINOCO AP-600B User Manual

Set the Distance Between APs (AP-600b Only)
[Device Name]>set wif 3 distaps <large, medium, small, minicell, microcell>
[Device Name]>reboot 0
1 2 7 ( 1 2 7 (
1 2 7 ( 1 2 7 (
The distance between APs should not be approximated. It is calculated by means of a manual Site Survey, in
which an AP-600 is set up and clients are tested throughout the area to determine signal strength and
coverage, and local limits such as physical interference are investigated. From these measurements the
appropriate cell size and density is determined, and the optimum distance between APs is calculated to suit
your particular business requirements.
Set the Multicast Rate (AP-600b Only)
[Device Name]>set wif 3 multrate <1,2,5.5,11 (Mbits/sec)>
1 2 7 ( 1 2 7 (
1 2 7 ( 1 2 7 (
The Distance Between APs must be set before the Multicast Rate.

Set Ethernet Speed and Transmission Mode

[Device Name]>set etherspeed <value (see below)>
[Device Name]>reboot 0
Ethernet Speed and Transmission Mode
10 Mbits/sec - half duplex
10 Mbits/sec - full duplex
10 Mbits/sec - auto duplex
100 Mbits/sec - half duplex
100 Mbits/sec - full duplex
Auto Speed - half duplex
Auto Speed - auto duplex

Set Interface Management Services

Edit Management IP Access Table
[Device Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
Configure Management Ports
[Device Name]>set snmpifbitmask <0 - 7 (default is 7 see below)>
[Device Name]>set httpifbitmask <0 - 7 (default is 7 see below)>
[Device Name]>set telifbitmask <0 - 7 (default is 7 see below)>
Choose from the following values:
Interface bitmask
0 or 2 = disable (all interfaces)
1 or 3 = Ethernet only
4 or 6 = Wireless only
5 or 7 = all interfaces
Set Communication Ports
[Device Name]>set httpport <HTTP port number (default is 80)>
[Device Name]>set telport <Telnet port number (default is 23)>
Value
10halfduplex
10fullduplex
10autoduplex
100halfduplex
100fullduplex
autohalfduplex
autoautoduplex (default)
Description
All management channels disabled
Ethernet only enabled
Wireless only enabled
All management channels enabled
Command Line Interface (CLI)
108