Table of Contents
Advertisement
Set Telnet Session Timeouts
[Device Name]>set tellogintout <time in seconds between 1 and 300 (default is 30)>
[Device Name]>set telsessiontout <time in seconds between 1 and 36000 (default is 900)>
Configure Serial Port Interface
1 2 7 (
1 2 7 (
1 2 7 (
1 2 7 (
To avoid unexpected performance issues, leave Flow Control at the default setting (none) unless you are sure
what this setting should be.
[Device Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device Name]>set serflowctrl <none, xon/xoff>
[Device Name]>show serial
Figure A-16 Result of "show serial" CLI Command
Configure Syslog
[Device Name]>set syslogpriority <1-7 (default is 6)>
[Device Name]>set syslogstatus <enable/disable>
Configure Intra BSS
[Device Name]>set intrabssoptype <passthru (default)/block)>
Configure MAC Access Control
Setup MAC (Address) Access Control
[Device Name]>set macaclstatus enable
[Device Name]>set macacloptype <passthru, block>
[Device Name]>reboot 0
Add an Entry to the MAC Access Control Table
[Device Name]>set macacltbl <index> macaddr <MAC Address> status enable
[Device Name]>show macacltbl
Disable or Delete an Entry in the MAC Access Control Table
[Device Name]>set macacltbl <index> status <disable/delete>
[Device Name]>show macacltbl
1 2 7 (
1 2 7 (
1 2 7 (
1 2 7 (
For larger networks that include multiple Access Points, you may prefer to maintain this list on a centralized
location using the RADIUS parameters (see
Command Line Interface (CLI)
Set RADIUS
Parameters).
109
Advertisement
Table of Contents
