Change Passwords; Set Network Names For The Wireless Interface - Proxim ORINOCO AP-600B User Manual

Figure A-12 Result of "show system" CLI Command
Set Static IP Address for the AP-600
1 2 7 ( 1 2 7 ( 1 2 7 ( 1 2 7 (
The IP Subnet Mask of the AP-600 must match your network's Subnet Mask.
[Device Name]>set ipaddrtype static
[Device Name]>set ipaddr <fixed IP address of unit>
[Device Name]>set ipsubmask <IP Mask (default = 255.0.0.0)>
[Device Name]>set ipgw <gateway IP address (default = 169.254.128.133)>
[Device Name]>show network

Change Passwords

[Device Name]>passwd <Old Password> <New Password> <Confirm Password> (CLI password)
[Device Name]>set httppasswd <New Password> (HTTP interface password)
[Device Name]>set snmprpasswd <New Password> (SNMP read password)
[Device Name]>set snmprwpasswd <New Password> (SNMP read/write)
[Device Name]>reboot 0
!
& $ 8 7 , 2 1 & $ 8 7 , 2 1
& $ 8 7 , 2 1 & $ 8 7 , 2 1
Proxim strongly urges you to change the default passwords to restrict access to your network devices to
authorized personnel. If you lose or forget your password settings, you can always perform the
Factory Default Procedure.

Set Network Names for the Wireless Interface

[Device Name]>set wif 3 netname <Network Name (SSID) for wireless interface>
[Device Name]>show wif
Figure A-13 Results of "show wif" CLI command for an AP-600a
Command Line Interface (CLI)
Reset to
104