2.
In the Transducer Setup menu, select the connected dual transducer from the list.
IMPORTANT
The proper selection of the dual transducer is critical for proper operation of the
Corrosion Module.
Figure 11-38 Corrosion Module transducer Setup menu
3.
Press
to continue.
4.
Follow the prompt to wipe the couplant off the probe, then press Continue
(P1 key).
The Corrosion Module automatically measures the zero offset of the probe delay
line (Do-Zero). The EPOCH 650 is now zeroed and ready to make measurements.
DMTA-10055-01EN, Rev. A, February 2015
Software Features and Options
279