9.11 Common Angle Beam Calibration Block Diagrams; Figure 9-30 The Astm E164 Iiw Type Calibration Block (P/N: Tb7541-1) - Olympus EPOCH 650 User Manual

2. Choose Trig > Diameter, and then enter the outer diameter of the inspection
piece.
3. If using Trig > CSC = Outer Dia, choose Trig > Thick and then enter the wall
thickness of the inspection piece.

9.11 Common Angle Beam Calibration Block Diagrams

Figure 9-30 on page 181 to Figure 9-36 on page 186 illustrate calibration blocks
commonly used with angle beam probes.

Figure 9-30 The ASTM E164 IIW type calibration block (P/N: TB7541-1)

NO LUCITE PLUG
DMTA-10055-01EN, Rev. A, February 2015
.050 .
TYP TOLERANCE
-
NON CUMULATIVE
22.86 mm
10.16 cm(4 in.)
(9 in.)
Calibration 181