Sflow Counter Poller Settings - D-Link DGS-3700 Series User Manual

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

sFlow Counter Poller Settings

This window is used to create the sflow counter poller settings on the Switch. Within the sflow counter poller function,
the port statistics counter information will be forwarded to the server at the configured interval. These counters are
RFC 2233 counters.
To view this window, click Configuration > sFlow > sFlow Counter Poller Settings as shown below:
The following parameters can be configured:
Parameter
From Port / To Port
Analyzer Server ID
(1-4)
Interval (20-120)
Click Apply to implement the changes made.
Figure 2 - 58 sFlow Counter Poller Settings window
Description
Specifies the port or list of ports to be configured.
The analyzer server id specifies the ID of a server analyzer where the packet will be
forwarded.
Specifies the maximum number of seconds between successive statistic counter information.
To disable the interval check the Disabled box.
50