3.
Click Submit to apply your changes.
4.
To save the changes to flash memory, see 'Saving Configuration' on page 482.
To delete a community string, select the Delete check box corresponding to the community
string that you want to delete, and then click Submit.
Table 5-1: SNMP Community String Parameters Description
Parameter
Community String
Trap Community String
[SNMPTrapCommunityString]
5.2
Configuring SNMP Trap Destinations
The SNMP Trap Destinations page allows you to configure up to five SNMP trap
managers.
To configure SNMP trap destinations:
1.
Open the SNMP Trap Destinations page (Maintenance tab > System menu >
Management submenu > SNMP submenu > SNMP Trap Destinations).
2.
Configure the SNMP trap manager parameters according to the table below.
3.
Click Submit to apply your changes.
4.
To save the changes to flash memory, see 'Saving Configuration' on page 482.
Note:
SIP User's Manual
Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Figure 5-1: SNMP Trap Destinations Page
Only table row entries whose corresponding check boxes are selected are
applied when clicking Submit; otherwise, settings revert to their defaults.
Description
76
Mediant 600 & Mediant 1000
Document #: LTRT-83310