Adjustment Of Radf Height - Toshiba e-STUDIO520 Service Handbook

3.11.2

Adjustment of RADF height

It is mainly performed at the installation. It is also required when the RADF is dislocated for some rea-
son such as moving the equipment.
Perform the following adjustment by using the screw of the left and right hinge.
Note: Note:
Perform this adjustment after "3.11.1 Adjustment of RADF position".
Turn the exposure lamp ON during the gap check. (Test Mode: 03-267)
<Procedure>
(1) Adjustment standard
Adjust the height so that the platen guide holder touches the ADF original glass.
(Adjust after removing the top left cover.)
(2) Adjust the height of the hinge by turning the height adjusting screw on the hinge.
CW: The height of the hinge becomes high.
CCW: The height of the hinge becomes low.
e-STUDIO520/523/600/603/720/723/850/853
ADJUSTMENT
Platen guide holder
ADF original glass ADF original glass
Fig. 3-63
Adjustment screw
Fig. 3-64
3 - 60
Platen guide holder
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved