Toshiba e-STUDIO520 Service Handbook page 569

When the FROM basic section software version of the equipment is "V1.04 / 2.38" or later:
Note: Note:
The display of items on this screen varies depending on the types of data written on the USB
storage device. Each item is displayed only when each data file is written on the USB storage
device in the following conditions.
Item
1. OS UI Update
2. HDD SYS Update
3. LSR Firmware Update
4. PFC Firmware Update
5. Engine Firmware Update
6. Scanner Firmware Update
If the USB storage device is not recognized properly, the following message is displayed. In this
case, disconnect the USB storage device and connect it again within 3 minutes, or turn OFF the
power of the equipment and connect the device properly. Then repeat the procedure from (5).
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Fig. 6-44
Condition
firmImage0.bin, firmImage1.bin are written.
All master data files (1, 2, 3 ... n) are written.
firmImage2.bin is written.
firmImage2.bin is written.
firmImage2.bin is written..
firmImage2.bin is written.
Fig. 6-45
6 - 45
06/09
e-STUDIO520/523/600/603/720/723/850/853
FIRMWARE UPDATING
6