Toshiba e-STUDIO520 Service Handbook page 400

[E723] Original not reaching small original reverse sensor (during scanning)
[E751] Original stopping at original intermediate transport sensor
[E752] Original not reaching original intermediate transport sensor
[E728] Original not reaching small original exit sensor (during scanning)
[E732] Original stopping at small original exit sensor
[E741] Original stopping at small original reverse sensor
[E742] Original not reaching small original reverse sensor (during reverse feeding)
[E743] Original not reaching small original exit sensor (during reverse feeding)
Are the registration roller, read roller and small original reverse roller stained?
YES
NO
Are the small original exit flapper and small original reverse flapper operating normally?
NO
Adjust the small original exit solenoid.
[E725] Original stopping at read sensor (while its back side is being scanned)
Are the read roller and registration roller stained?
YES
NO
Replace the rollers.
[E726] Transport/exit signal reception jam
1) If the original remains in the RADF, remove it.
2) If any paper remains in the equipment, remove it.
3) Turn the power OFF and then back ON. If the jam still occurs, lead the following proce-
dure.
4) Check the connection between the ADF board and SLG board, and the connection
between the ADF board and switching power supply.
- Are the connection of the connectors and joint connectors normal?
- Are the connector pins disconnected or are the harnesses open circuited?
5) Check if the 24V and 5V outputs of the switching power supply are normal.
6) Check if the conductor pattern on the ADF board is short circuited or open circuited.
7) Replace the ADF board.
8) Check if the conductor pattern on the SLG board is short circuited or open circuited.
9) Replace the SLG board.
e-STUDIO520/523/600/603/720/723/850/853
TROUBLESHOOTING
Clean the rollers.
Clean the rollers.
5 - 38
05/05
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved