Toshiba e-STUDIO520 Service Handbook page 244

For tandem LCF
Order for
Paper source
adjustment
1 1st drawer
2 2nd drawer
3 Tandem LCF
4 LCF
5 Bypass feed
6 Duplexing
- All
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [1] ([3] for duplexing)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance D is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode)
(Key in an acceptable value shown above)
[ENTER] or [INTERRUPT] (Stored in memory)
"100% A" is displayed
Press [1] ([3] for duplexing)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
e-STUDIO520/523/600/603/720/723/850/853
ADJUSTMENT
Code Paper size
440 A4
441 A3
429 A4
443 A4
442 A3
445 A3
408 -
[FAX]. (A grid pattern with 10 mm squares is printed out.)
(Key in the code shown above)
[FAX] (A grid pattern is printed out.)
3 - 12
Acceptable
value
0 to 40
0 to 40
0 to 40
0 to 40
0 to 40
0 to 40 Paper fed from the 2nd/4th drawer
0 to 80
(Adjustment Mode)
[START]
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Remarks