Toshiba e-STUDIO520 Service Handbook page 68

Procedure 6
[0][5] [Digital key]
(Code)
[POWER]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 7
[Digital key]
[0][5]
(Code)
[POWER]
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 17
[ CANCEL ] or [ CLEAR ]
[ 0 ][ 5 ]
[ Digital key ]
[ POWER ]
( Code )
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
e-STUDIO520/523/600/603/720/723/850/853
ERROR CODE AND SELF-DIAGNOSTIC MODE
( Automatic
[START]
adjustment
*[CANCEL] or [CLEAR]
[CANCEL]
Automatic
(
[START]
adjustment
[Digital key]
[START]
(Sub code)
[SET] or [INTERRUPT]
(Value unchangeable)
[ START ] ( Automatic )
[ INTERRUPT ]
adjustment
(
2 - 42
05/05
([FAX]
)
or
[COPY])
(Test copy)
[ENTER]
)
Stores value
( )
in RAM
Value
(
[START]
displayed
[ ENTER ] ([ FAX ]
or or
[ COPY ])
( Test copy )
Stores value )
in RAM
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
[POWER]OFF/ON
(Exit)
([FAX]
[POWER]
or
OFF/ON
[COPY])
(Exit)
(Test copy)
[POWER]
)
[START] OFF/ON
(Exit)
[ POWER ]
OFF/ON
( Exit )