Toshiba e-STUDIO520 Service Handbook page 245

[E] Primary scanning data laser writing start position at duplexing
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1] Adjustment for long-sized paper
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [3] [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD in the 2nd/4th
drawer.
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[ENTER] or [INTERRUPT] (Stored in memory)
"100% A" is displayed.
Press [3] [FAX]
* The larger the adjustment value is, the longer the distance E becomes (0.05 mm/step).
[E-2] Adjustment for short-sized paper
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [3] [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT in the 1st
drawer/tandem LCF.
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[ENTER] or [INTERRUPT] (Stored in memory).
"100% A" is displayed
Press [3] [FAX]
* The larger the adjustment value is, the longer the distance E becomes (0.05 mm/step).
<Adjustment procedure summarization for A to E>
[0] [5] [Power ON] [1] ([3](05-445, 498) for duplex)
A: 05-401 (2nd/4th drawer, A3/LD)
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
(Key in code [498]) [START]
(A grid pattern is printed out.)
(Key in the code [498])
(A grid pattern is printed out.)
3 - 13
07/11
(Adjustment Mode)
[0] [START]
(Adjustment Mode)
[START] [1] [START]
[FAX]
200±0.5 mm
(e-STUDIO 520/523/600/603/720/723:
0.3 mm/step,
e-STUDIO 850/853: 0.1 mm/step)
e-STUDIO520/523/600/603/720/723/850/853
3
ADJUSTMENT