Toshiba e-STUDIO520 Service Handbook page 479

[3D10] Destination address error
Check if the setting of the server or DNS is correct. Correct if any of the setting is incorrect.
When the content of the setting is correct, confirm the sender if the destination is correct.
[3D20] Offramp destination limitation error
Inform the sender that the transfer of the FAX data over 40 is not supported.
[3D30] FAX board error
This error occurs when the FAX board is not installed or the FAX board has an abnormality.
Check if the FAX board is correctly connected.
[3E10] POP3 server connection error
Check if the IP address or domain name of the POP3 server set for this equipment is correct, or check
if POP3 server to be connected is operating properly.
[3E20] POP3 server connection time-out error
5
Check if POP3 server to be connected is operating properly.
Check if the LAN cable is correctly connected.
[3E30] POP3 login error
Check if the POP3 server login name and password set for this equipment are correct.
[3E40] POP3 Login Type ERROR
Check that the login type (Auto, POP3 or APOP) to the POP3 server is correct.
[3F00] [3F10] [3F20] [3F30] [3F40] File I/O error
These errors occur when the mail data is not transferred properly to the HDD.
Request the sender to retransmit the mail.
Replace the HDD if the error still occurs after retransmission.
[4030] No printer kit/Invalid
Install the print kit and perform the job again.
Install the Expansion Memory (GC-1230) and perform the job again.
Register it officially and perform the job again.
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO520/523/600/603/720/723/850/853
TROUBLESHOOTING
5 - 117
07/11