Toshiba e-STUDIO520 Service Handbook page 297

[B] Small original exit solenoid
<Procedure>
(1) Put the end faces of the bracket and solenoid
together.
(2) When the small original exit flapper is not
pulled out completely, loosen the screws and
then shift the solenoid upward.
(3) When the small original exit flapper is pulled
out completely, tighten and fix the screws
[C] Large original exit solenoid
<Adjustment procedure>
(1) Put the end faces of the bracket and solenoid
together.
(2) When the large original exit flapper is not
pulled out completely, loosen the screw and
then shift the solenoid upward.
(3) When the large original exit flapper is pulled
out completely, tighten and fix the screw.
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Ends faced-up
Fig. 3-73
Ends faced-up
Fig. 3-74
e-STUDIO520/523/600/603/720/723/850/853
3 - 65
3
ADJUSTMENT