Toshiba e-STUDIO520 Service Handbook page 389

[E120] Bypass misfeeding (paper not reaching registration sensor)
Open the bypass unit cover. Is there any paper in front of the registration sensor?
YES
NO
Is the registration sensor working?
(Perform the input check in the test mode: 03-[FAX]ON/[4]/[E])
l NO
l
l
l
l
l
l
l
YES
Is the width of the side guides of the bypass unit too narrow?
Is the paper skewed?
YES
NO
Is the bypass feed clutch working? (Perform the output check in the test mode: 03-204)
Is the bypass feed sensor working? (Perform the input check in the test mode: 03-
[FAX]OFF/[6]/[G])
l NO
l
l
l
l
l
l
l
l
YES
Check the bypass transport roller, feed separation and separation rollers.
Clean or replace them.
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Remove the paper.
1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN341 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the registration sensor.
6) Replace the LGC board.
Match the width of the side guides and that of the paper.
1) Check if the connector of the bypass feed clutch and bypass feed
sensor are disconnected.
2) Check if the connector CN327 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the bypass feed clutch and bypass feel sensor.
6) Replace the LGC board.
5 - 27
e-STUDIO520/523/600/603/720/723/850/853
TROUBLESHOOTING
5