Toshiba e-STUDIO520 Service Handbook page 289

(3) Close the RADF to check that the positioning
pins fit smoothly into the holes on the RADF.
If they do not, adjust them according to the
following procedure.
(4) Loosen the stepped screw 1 turn and 2
screws on the adjustment plate a half turn
(status of temporary fixing).
(5) Remove the stepped screw at the rear of
right-hand hinge.
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-54
2 screws: Half turn
Fig. 3-55
Fig. 3-56
e-STUDIO520/523/600/603/720/723/850/853
3 - 57
Stepped screw: 1 turn
ADJUSTMENT
3