Bit Switch Tables - Ricoh FACSIMILE FAX77 Field Service Manual

2. Bit Switch Tables

Bit Switch 0
BIT FUNCTION
Back to back con-
0
figuration
1 Memory read/write 0: Accepted
request
Action when other
2
end does not
respond to DIS
after three tries
Running a
3
Keystroke Program key to run the program.
Continued on the next page
DATA
0: Disabled
1: Enabled
1: Not accepted
0: The buzzer sounds
1: DCN sent
0: Press the program
1: Press the key then
the Start key to run the
program.
To connect two machines directly without using a regular
telephone company line, set this bit to 1, place a document in
one machine, and press Start on both machines. Do not dial a
number. After the test, reset this bit to 0.
When this bit is 0, a remote control system can read or write
RAM data such as TTl, RTI, and Bit Switches. The requester
must know the RAM addresses of this machine to make any
changes.
When this bit is 1, all requesters are locked out.
0: The buzzer warns that communication has failed. The user
must pick up the handset and press Stop.
1: No user intervention is needed. Also, when in auto receive
mode and if the speaker is switched off, the user will not be
able to talk to the sender before reception.
Note that if this bit is 0, the user must press Stop immediately
after programming a Keystroke Program, or the program will
start immediately. This is an Austrian PTT requirement.
2-35
COMMENTS