Ricoh FACSIMILE FAX77 Field Service Manual page 70

Bit Switch 2 - Continued
FUNCTION
BIT
Coding type (tx mode)
5 Bit 6 Bit 5 Setting
MH and MR
0 0
MH and MR
6 0 1
1 0 MH only
1 1 Not used
7 Recognition of
remote terminal's
paper length
DATA
0: Unlimited length as-
sumed
1: Limit specified by the the protocol from the other end.
other end is recognized
(0,0), (0,1) - The machine will send MR data. If the other end
cannot receive MR data, MH data will be sent.
(1,0) - The machine will send MH coded data only.
0: The unit always assumes the other end has no rx paper
length limit (paper roll), and ignores the paper length limit in
1: Use this setting if the unit often sends to machines that use
cut paper. For example, if the receiver specifies A4 paper in
the protocol but the local machine is sending a B4-length
page, the local machine will send MPS when it has sent an A4
length of data. The other end will feed another sheet of copy
paper and the local machine will send the remaining data.
2-39
COMMENTS