Ricoh FACSIMILE FAX77 Field Service Manual page 81

Bit Switch 9
BIT FUNCTION
0 Not used
1 Black line in the
image in G2 mode
(Austria only)
2 Not used
Transmission of
3
Group Identification 1: Disabled
(Gl) signal in
receive mode
4 Substitute recep-
tion
5 Not used
6 Condition for SAF
memory reception
7 Not used
DATA
0: Included
1: Deleted
0: Enabled
0: Enabled
1: Disabled
0: The SAF can receive 0: The SAF can store pages from the other end even if the
with or without the
detection of RTI or CSI. bother to program these identifiers, so this bit must be at 0 to
1: The SAF can only
receive if CSI or RTI
has been detected.
Do not change the factory setting.
If this bit is 1, the black line on the left side of the image (used
for synchronization) will be cut out.
Do not change the factory setting.
0: The machine informs the transmitter that it can receive G2
messages.
1: The machine indicates that it cannot receive in G2 mode.
Caution: If this bit is 1 and if bit 1 of bit switch A is also 1, the
machine cannot send out any signals.
In W. Germany, this bit must be 1. This bit is changed by Func-
tion 59 in the FAX80. If this bit is 0, bit 2 of bit switch 8 must
be 1.
Do not change the factory setting.
other end did not send an RTI or CSI. Some users do not
receive messages from these users into memory.
1: If the machine does not receive an RTI or CSI from the
other end, reception into memory is impossible.
Do not change the factory setting.
2-50
COMMENTS