Ricoh FACSIMILE FAX77 Field Service Manual page 164

Code Meaning
1-23
Cutter jam
1-24 Cutter was not at its initial position
when the machine was switched on
1-30 Paper ran out during printing
1-33 Paper end was detected when the
machine was switched on
1-34 Paper ended after printing a page
Suggested Cause/Action
1. Clear debris from the paper path and sensors.
2. Check cutter mechanism.
3. Check connections from the FCU to the cutter motor and
cutter sensor.
4. Replace defective cutter motor, sensor, or FCU.
1. Clear debris from the paper path and sensors.
2. Check cutter mechanism.
3. Check connections from the FCU to the cutter motor and
cutter sensor.
4. Replace defective cutter motor, sensor, or FCU.
1. Replace paper.
2. Clear debris from the paper end sensor.
3. Re-initialize the paper end sensor (see "Test Mode - Sensor
Initialization", page 2-27).
4. Check connections between the paper end sensor and the
FCU.
5. Replace the paper end sensor or FCU.
See code 1-30.
See code 1-30.
5-22