Installation; Installing The Machine; Initial Programming - Ricoh MV310 Service Manual

May 22nd, 1995

3. INSTALLATION

3.1. INSTALLING THE MACHINE

Refer to the Operator's Manual for the installation environment and how to in-
stall and set up the machine.
Note: The red clip [A] (P/N
H5211161) prevents the scan-
ner from moving during
transportation. This clip has
to be removed at installation,
and it has to be installed
again before transportation.
Refer to section 2.4.5 for how to set up the NCU hardware in each country.

3.2. INITIAL PROGRAMMING

Items to Program (Service Level)
Country code (NCU parameter 00)
Country code (System switch 0F)
Protocol requirements (G3 switch 0B)
PABX access code (RAM address 8000BB)
Machine's serial number
Service station's fax number
PM call (System switch 01 - bit 0)
Periodic service call (RAM address 800256)
Items to Program (User Administrator Level)
Clock
Initial programming items (IDs)
On/off switches
Display/report language
PABX access method (User parameter switch 13 - bits 0, 1)
Fusing power control during power saver mode
(User parameter switch 05 - bit 6)
INSTALLING THE MACHINE
3-1
INSTALLATION
[A]
H521I501.wmf
Function No.
Function 08
Function 01
Function 01
Function 06
Function 14
Function 13
Function 01
Function 06
Function No.
Function 91
Function 61
Function 62
Function 93
Function 63
Function 63