Ricoh FACSIMILE FAX77 Field Service Manual page 95

Bit Switch 14
BIT
FUNCTION
0 New file report prin- 0: Enabled
tout after storing
1 Printout of image
data sample on
error reports for
failed memory
transmissions
2 Action when rx er-
rors occur during
memory reception
(if PIN or RTN were
received)
Multicopy mode
3
(FAX85 only)
4 Not used
5 Erasing incoming
fax messages from
memory immedi-
ately after printing
Continued on the next page.
DATA
1: Disabled
0: Enabled
1: Disabled
0: Data is erased
1: Data is kept
0: Disabled
1: Enabled
0: Yes 1: No
This report gives information about the file just stored, for the
user's reference.
0: A sample of the message sent from memory can be printed
at the bottom of the error report as a reference if transmission
failed. This bit is ignored if bit 1 of bit switch B is 1.
0: If there are errors during memory reception, the message
will be erased from the memory, and the user will have to ask
the sender to resend the message.
1: If there are errors during memory reception, the message
will be stored in memory, complete with errors.
If this bit is at 0, Function 77 cannot be used.
Do not change the factory setting.
Fax messages are stored into memory at the same time as
printing so that data will not be lost if a printer fault develops
during printing
If this bit is 0, the message will be automatically cleared from
memory immediately after printing.
If this bit is 1, the message will not be cleared from memory;
the user must clear the message using Function 67.
2-64
COMMENTS