Cutter - Ricoh FACSIMILE FAX77 Field Service Manual

3-3-3. Cutter

1. Remove the cover on the left side of the
machine above the copy exit (2 screws).
This allows the upper unit to be opened a
little more.
2. Open the upper unit.
3. Remove the rear cover (see section 3-1-3).
4. Remove plate [A] (1 screw).
5. Remove the sensor cover [B] (2 screws).
6. Remove the cutter [C] (1 connector, 2
screws)
7. Install the new cutter. The clearance [D]
between the cutter and the platen roller
must be 0.3 mm. Loosen the screws
removed in step 6 and move the cutter
back and forth to adjust the clearance.
8. Reassemble.
3-24