Ricoh FACSIMILE FAX77 Field Service Manual page 76

Bit Switch 6
BIT FUNCTION
0 Confidential trans- 0: Enabled
mission
1 Transfer request
2 Eight-minute close 0: Disabled
3 Printout of image
data sample on
memory tx reports
even if transmis-
sion was unsuc-
cessful
4 Not used
Not used
5
6 Not used
7 Fallback on receiv- 0: No 1: Yes
ing a negative
receipt signal
DATA
1: Disabled
0: Enabled
1: Disabled
1: Enabled
0: Disabled
1: Enabled
Used in W. Germany only.
Used in W. Germany only.
If this bit is at 1, the machine will cut the line after a transmis-
sion has lasted for 8 minutes. Used in W. Germany only.
For the user's reference, a sample of the message sent from
memory is printed at the bottom of the memory transmission
report if the transmission fails. If this bit is 1, the sample will
also be printed if the transmission succeeds. This bit is ig-
nored if bit 7 of bit switch 13 is 1.
Do not change the factory setting.
Do not change the factory setting.
Do not change the factory setting.
If this bit is 1, the machine's tx modem rate will fall back
before sending the next page if a negative code is received.
This bit is ignored if ECM is being used.
2-45
COMMENTS