Ricoh FACSIMILE FAX77 Field Service Manual page 158

Meaning
Code
0-07 Other end did not acknowledge
receipt of a page (G3 mode)
The other end sent RTN or PIN
0-08
after receiving a page, because
there were too many errors (G3
mode)
0-14 Non-standard post message
response code received (G3 mode)
0-15 Other end does not have the con-
fidential or transfer function (G3
mode)
Suggested Cause/Action
1. Check line connection.
2. Check connectors from FCU to modem and NCU.
3. Replace the NCU, FCU, or modem.
4. The other end may have jammed or run out of paper.
5. The other end user disconnected the call.
6. Check for a bad line.
1. Check line connection.
2. Check connectors from FCU to modem and NCU.
3. Replace the NCU, FCU, or modem.
4. The other end may have jammed, or run out of paper or
memory space.
5. Try adjusting the tx level (use bit switch 3 or a dedicated tx
parameter for that address).
6. The other end may have a defective modem/NCU/FCU.
7. Check for line problems and noise.
1. Incompatible or defective remote terminal.
2. Noisy line: resend.
3. Replace the FCU or modem.
1. Incompatible remote terminal.
2. Remote terminal memory full.
5-16