Ram Data Display And Rewrite - Function - Ricoh FACSIMILE FAX77 Field Service Manual

The settings of bit switch 0 should be displayed. The top line shows the factory settings, and the bottom
3.
line shows the current settings. Bit 0 is at the right end of the display, and bit 7 is at the left.
4. Make your changes.
Press # to go to the next bit switch, or press * to go back. Hold down #/* for fast motion.
Example: For bit switch 1, press # once.
Press the key on the ten key pad that corresponds to the bit that you want to change.
Example: Change the setting of bit 6; press 6.
5. Either:
Change more bit switches using step 4.
Press Function to return to standby.

6. RAM Data Display and Rewrite - Function 91

Caution: Consult technical services before changing the contents of a RAM address.
1. Enter the service mode. See page 2-13.
2. Press the Function key, enter 91, then press Yes.
Type in the address that you wish to see (0 to 9 at the ten key pad, A to F at the Quick Dial keypad). You
3.
cannot view data in any address higher than 7FFF.
Continued on the next page.
2-19