Ricoh FACSIMILE FAX77 Field Service Manual page 79

Bit Switch 8
BIT FUNCTION
0 Not used
1
Printout of received 0: Page printed only as
pages if ECM is
used (non-memory data.
reception)
2 ECM in rx mode
Initial Rx modem rate
Bit 4 Bit 3
3 Setting
0 0 9600 bps
4 0 1 7200 bps
1 0
4800 bps
1 1
2400 bps
Continued on the next page
DATA
far as the defective
1: The whole page is
printed, except for the
errors.
0: Enabled
1: Disabled
Do not change the factory setting.
0: If there is an error, the data after that error will not be
printed.
1: The complete page will be printed, except for the frames
which contain errors.
This bit is not changed by Function 83, however, if the user
switches Function 59 on, this bit will automatically reset to 1.
In the FAX80, this bit and bit 4 of bit switch 9 must not both be
zero.
The setting of these bits is used to inform the sending
machine of the initial starting modem rate for the machine in rx
mode. If 9600 bps presents a problem during rx, use a lower
setting.
2-48
COMMENTS