Displaying The Zero Offset "Overview - Siemens SINUMERIK 840D sl Operating Manual

Setting up the machine
2.7 Zero offsets
Procedure
Note
Further details on zero offsets
If you would like to see further details about the specified offsets or if you would like to
change values for the rotation, scaling or mirroring, press the "Details" softkey.
2.7.2

Displaying the zero offset "overview"

The active offsets or system offsets are displayed for all set-up axes in the "Zero Offset -
Overview" window.
In addition to the offset (course and fine), the rotation, scaling and mirroring defined using
this are also displayed.
This window is generally used only for monitoring.
Display of active zero offsets
Zero offsets
DRF
Rotary table reference
Basic reference
External ZO frame
Total base ZO
84
1. Select the "Parameter" operating area.
2. Press the "Zero offset" softkey.
The "Zero Offset - Active" window is opened.
Displays the handwheel axis offset.
Displays the additional zero offsets programmed with $
P_PARTFRAME.
Displays the additional zero offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional zero offsets programmed with $P_EXTFRAME.
Displays all effective basis offsets.
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Turning