Siemens SINUMERIK 840D sl Operating Manual page 256

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Creating a ShopTurn program
7.16 Programming the approach/retraction cycle
Table 7- 1
Parameters
F1
X1
Z1
F2
X2
Z2
F3
X3
Z3
Tool change
T
D
F4
X4
Z4
F5
X5
Z5
F6
X6
Z6
256
Description
Feedrate to approach the first position
Alternatively, rapid traverse
1. position ∅ (abs) or 1st position (inc)
1. position (abs or inc)
Feedrate for approach to the second position
Alternatively, rapid traverse
2. position ∅ (abs) or 2nd position (inc)
2. position (abs or inc)
Feedrate to approach the third position
Alternatively, rapid traverse
3. position ∅ (abs) or 3rd position (inc)
3. position (abs or inc)
TlChngPt: Approach the tool change point from the last programmed position and
carry out a tool change
direct: Tool is not changed at the tool change position, but at the last programmed
position
No: Tool is not changed
Tool name - (only for "direct" tool change)
Cutting edge number - (only for "direct" tool change)
Feedrate for approach to the fourth position
Alternatively, rapid traverse
4. position ∅ (abs) or 4th position (inc)
4. position (abs or inc)
Feedrate to approach the fifth position
Alternatively, rapid traverse
5. position ∅ (abs) or 5th position (inc)
5. position (abs or inc)
Feedrate to approach the sixth position
Alternatively, rapid traverse
6. position ∅ (abs) or 6th position (inc)
6. position (abs or inc)
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Unit
mm/min
mm (in)
mm
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
Turning

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d turning

Table of Contents