Siemens SINUMERIK 840D sl Operating Manual page 536

Multi-channel machining (only 840D sl)
9.2 Multi-channel support (only 840D sl)
Parameter
Measurement unit
Main spindle
Work offset
Write to the
work offset
ZV
Blank
XA
XI
ZA
ZI
ZB
N
SW or L
W
L
S
Spindle chuck
data
536
Description
Selecting the measurement unit
Selecting the work offset
Yes
•
Parameter ZV is displayed
No
•
Parameter ZV is not displayed
Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please refer to the machine manufacturer's instructions.
Tube
•
Cylinder
•
Polygon
•
Centered cuboid
•
Outside diameter ∅ – for tube and cylinder
Inside diameter (abs) or wall thickness (inc) – only for tube
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Number of edges – only for polygon
Width across flats or edge length – only for polygon
Width of the blank - only for centered cuboid
Length of the blank - only for centered cuboid
Speed limitation of the main spindle
Yes
•
You enter spindle chuck data in the program.
No
•
Spindle chuck data are transferred from the setting data.
Note:
Please observe the machine manufacturer's instructions.
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Unit
mm
inch
mm
mm
mm
mm
mm
mm
mm
rev/min
Turning