8.3.7
Contour call (CYCLE62) - only for G code program
Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
2. Labels
3. Subprogram
4. Labels in the subprogram
Procedure
Parameter
Contour selection
Contour name
Labels
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
The contour is in the calling main program.
The contour is in the calling main program and is limited by the labels that have been
entered.
The contour is located in a subprogram in the same workpiece.
The contour is in a subprogram and is limited by the labels that have been entered.
1.
The part program to be executed has been created and you are in the
editor.
2.
Press the "Contour turning" softkey.
3.
Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
4.
Assign parameters to the contour selection.
Description
Contour name
•
Labels
•
Subprogram
•
Labels in the subprogram
•
CON: Contour name
LAB1: Label 1
•
LAB2: Label 2
•
Programming technology functions (cycles)
8.3 Contour turning
Unit
355