Contour Turning With Manual Machine - Siemens SINUMERIK 840D sl Operating Manual

14.6.3

Contour turning with Manual machine

For contour turning of simple geometric shapes, the same range of technological functions
(cycles) as in automatic mode is available.
Parameters
The parameters of the input screen forms correspond to the parameters under Automatic
(see Section "Contour turning (Page 342)").
Last contour
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Machine manufacturer
Please refer to the machine manufacturer's specifications.
⇒
If you have created a contour since the startup of the machine, the softkey
"Last contour" is available to you. You have thus the option to reopen the input
screen with the last contour you entered in "Manual machine" for editing.
Working with Manual Machine
14.6 More complex machining
⇒
721