Siemens SINUMERIK 840D sl Operating Manual page 435

Parameter Description
Position
At the front (face)
•
At the rear (face)
•
Outside (peripheral surface)
•
(only for
ShopTurn)
Inside (peripheral surface)
•
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for
ShopTurn)
Alignment
•
•
•
Reference point Position of the reference point
•
•
•
•
•
•
•
•
•
Mirror writing
Yes
•
The mirrored text is engraved on the workpiece.
No
•
The text is engraved on the workpiece without mirroring.
Engraving text maximum 100 characters
The positions refer to the reference point:
X0 or R Reference point X or reference point length polar
Y0 or α0 Reference point Y or reference point angle polar
Z0 Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 Reference point Z
(only ShopTurn)
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
(linear alignment)
(curved alignment)
(curved alignment)
bottom left
bottom center
bottom right
top left
top center
top right
left-hand edge
center
right-hand edge
Programming technology functions (cycles)
8.4 Milling
Unit
mm
mm or
degrees
mm
mm
mm or
degrees
mm
435