Working with two tool carriers
16.2 Measure tool
In the simulation, the tool is always displayed on the correct side, just the same as it is used
at the machine.
The programmed C offset around 180° only affects C axes, not spindles.
It is not possible to machine a thread with tools that are distributed between both tool
holders.
G code programming
The following points must be taken into account for G code programming:
● After a tool change, tool mirroring on the second tool holder is automatically activated.
● When a TRANSMIT command is programmed, tool mirroring on the second tool holder is
16.2
Measure tool
Selection options "Toolholder 1" and "Toolholder 2" are available for scratching when
measuring a tool. This is how you set the tool holder in which the tool to be measured is
located.
738
automatically activated.
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Turning